Power factor for industrial plants in Tijuana

A low power factor means the plant draws more current than it turns into useful work. In Tijuana that shows up on the utility bill, in warm feeders and in switchgear that has little spare capacity. Alianza starts from an on-site measurement, not from a generic figure.

With that data we propose the correction: an operating adjustment, a capacitor bank or a combination. Supply and installation of the bank are covered in capacitor banks in Tijuana. If this is part of a broader study, we tie it to the Código de Red page.

• Measurement of power factor and demand during operation.
• Diagnosis of causes visible in the measurement.
• A correction proposal and, when it applies, installation of the bank.
• A report for the plant file.

1. Review bills or the demand profile, if you have them.
2. Measure on site with the plant running.
3. Calculate the correction and present the proposal.
4. Install, start up and document the result.

• A recent bill or a reading of demand and power factor.
• Access to the electrical room or the substation for the measurement.
• A time window when the plant runs at representative load.

Thermography of the switchgear, if you want it on the same visit, is on industrial thermography in Tijuana.

Share a recent utility bill or demand data and we will tell you how to start the measurement. WhatsApp 664 604 1810 or [email protected].